- Use suction lift to move plywood sheets to milling board on table for inspection and prep prior to loading the router.
- Slide plywood sheet and milling board from roller table to router and fit into place.
- Load/Select work order on touch screen and initiate cut.
- Pull cut parts and stack on frame buggy.
- Break up plywood scrap and place in scrap buggy, then sweep floor around work area/CNC.
- Push frame buggy to line up and push scrap buggy when1/2 full to grinder conveyor and dump scraps.
- Roll milling board through vacuum system to remove dust and then slide board back to inspect/load table.
- Clean router table using air restricted blow gun and/or vacuum to remove excess dust.
- Use forklift to restock plywood sheets by picking up a hack of plywood (35 sheets) from stock and take it to router.
- Weekly clean-up - Hit the "E" Stop switch and climb on machine to wipe down.
- May perform other duties/ special or non-routine assignments as instructed.
Requirements:
- Ability to read and follow directions (verbal and written) May require basic math skills: counting, adding and subtracting
- Ability to lift up to 50lbs
- Previous experience preferred
- Job Function 7A Highly Skilled Operators
- Pay Type Hourly
- Travel Required No
- Required Education High School